All posts by AlexG


I found the british store , which offers building kits, made out of ressin. It is unpainted, but it is weather proof. I ordered it already in october and received it just two weeks after. Finally in january I had the time to glue and paint it. Today I put in on my railway for the very first time.

It perfectly fits into the landscape! I love these british building kits! Way better than the plastic kits.


The goal for this year was to build a waterfall, create a railway station in front of it, to expand the tracks up to the corner of my backyard and to finish the gardening up to this point.

Well – my wife and I went to a huge gardening shop yesterday, bought some small bushes and flowers and I put them in the place we wanted them to be. This week I also finished the stationary platform in front of the waterfall using concrete and today I put some lights to the station.

So I’m done with my railway working for this year – at least for the work outdoors. 


The railway station was done – well – almost. Some light was missing. I had some brass tubes left from a renovation and some white plastic balls from a defect light chain. The plastic balls fit perfectly into the brass tube and a 5mm LED is fitting into the balls. So the only thing that was missing was a little bit of electronics to connect the LED to the 18VAC rails. Just a 1k resistor and another diode solved it. So just a few cent of investment to build some nice lamps for the railway platform.


The ordinary joint controller is build with a usual electric coil and a permanent magnet, that is turing the rails. It really fast, but not really powerful. Just a little piece of gravel is prohibiting its functionality. The resultis really frustrating. So I decided to change this behaviour.

First idea was to use a servo, but the creation of a PWM signal for its control is simply too complicated. So why not usinga simple electric motor with a micro gearbox? Well – that sounds perfect. DC motors are able to spin in both directions. I found a DC motor in an electronic online shop with an integrated 1:1000 gearbox. Next step is to establish an automatic end switch for both directions. I found a great circuit digram in the net. So with some patience I used to original case and replaced to content.

It is working in perfecting. It is moving very smooth, but also very powerful. It is that strong, that it my push 12 kg (24pds)!!! So there shouldn’t be any issue anymore! Let’s turn joints!


Great weather and time to work. So it is getting time to dosome gardening and set the grass seperator. 4 hours and 240 kg of concrete later I call it the day. After getting some earth out and putting some gravel below als stones are set in concrete.

Next step will be setting the fundamental basement for the tracks. But not today. I feels stoned – need a cold beer.


Prepearation for the last step of track extention for 2017. Goal is to get the tracks in front of the waterfall. So about 5 meters (15 feet) are missing. To keep the grass away from the tracks, a speparation need to be made. First step was to lay down some stones in the way the separation is planed. Second step is to cut off the grass. For getting an idea, how it would look alike, I simply put the tracks temporarly on the earth.


After a long period of time, I had the mood to make something new to my garden railway. I build a railring to my bridge. Before summer vacations I already prepared some wood and put some paint on it. Today I screwed it under the tracks. After that I soldered some blank cupper wired to a railing and sprayed it with silver color.